🔎 Tohatsu MFS4/5/6C Reference Library — Exploded parts diagrams (17 diagrams), specifications, common issues, and maintenance checklist.
The Tohatsu MFS4/5/6C is a 4-Stroke Single Cylinder outboard motor. Designed for dinghies, inflatable boats, and small tenders where lightweight portability is essential.
Quick Reference Specifications
| Specification |
Value |
| Engine Type |
4-Stroke Single Cylinder |
| Horsepower |
4 HP |
| Displacement |
123 cc |
| Bore x Stroke |
59.0 x 45.0 mm |
| Spark Plug (Type & Gap) |
NGK DCPR6E |
| Engine Oil Capacity |
0.45 L |
| Recommended Engine Oil |
SAE 10W-30 |
| Gear Case Oil Capacity |
0.195 L |
| Idle Speed (in gear) |
— |
| Full Throttle RPM Range |
5000-6000 RPM |
| Fuel |
Unleaded Gasoline, 87 Octane min. |
Always verify specifications against your owner's manual for your specific serial number range.
Common Issues & Recommended Parts
Below are common maintenance scenarios for the Tohatsu MFS4/5/6C:
-
Water Pump / Overheating: If the tell-tale stream is weak or absent, the water pump impeller likely needs replacement. Inspect annually or every 100 hours. → Recommended: Water Pump Impeller Kit
-
Engine Oil / Maintenance Light: 4-stroke engines require regular oil and filter changes. Use marine-grade oil rated for your engine. Change every 100 hours or annually. → Recommended: Oil Filter, Engine Oil
-
Fuel Injector Issues (EFI models): Rough idle or misfires may indicate clogged fuel injectors. Use fuel stabilizer and clean injectors periodically. → Recommended: Fuel Injector, Fuel Filter
-
Gear Case Oil Leak: Check lower unit seals if gear oil appears milky (water contamination). Replace seals and gaskets during lower unit service. → Recommended: Lower Unit Seal Kit, Drain Plug Gaskets
-
Anode Corrosion: Inspect sacrificial anodes regularly, especially in saltwater. Replace when 50% depleted to protect against galvanic corrosion. → Recommended: Zinc/Aluminum Anode Kit
100-Hour / Annual Service Checklist
Regular maintenance keeps your Tohatsu MFS4/5/6C running reliably season after season. Most of these tasks can be performed with basic tools and the factory service manual.
- Replace water pump impeller and inspect wear plate
- Change engine oil and oil filter (check drain plug washer)
- Replace spark plugs and check ignition timing
- Drain and refill lower unit gear oil; inspect for water contamination
- Inspect fuel lines, primer bulb, and fuel filter for deterioration
- Check and replace sacrificial anodes (zinc or aluminum)
- Inspect propeller for damage; check shaft seal and cotter pin
- Check valve clearance (refer to service manual for specifications)
- Lubricate all grease points (steering, tilt tube, shift linkage)
- Inspect control cables and throttle/shift linkage for smooth operation
-
Pro Tip: Always flush the engine with fresh water after saltwater use — even a quick 10-minute flush significantly extends component life.
-
Pro Tip: Use fuel stabilizer in the tank before winter storage, and fog the cylinders to prevent internal corrosion during extended periods of non-use.
